Sziasztok
Erről a szervórol találtam pár érdekes adatot:
Ime a magyar országi forgalmazó által ismertetett adatok:
- fémfogaskerekes szervó
- súlya: 62g
- feszültség: 3,0V-7,2V
- sebesség:
4,8V 0,17"/60° vagy 6V 0,13"/60°- nyomaték:
4,8V 10,2 kg vagy 6V 13,5 kg
Itt a link:
http://bolthely.hu/rcshop/modules.php?name=termek&id=0285
Itt pedig egy másik helyen talált adatokak szeretnék megmutatni:
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-7.2 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.20sec/60 degrees
Operating Speed (6.0V): 0.19sec/60 degrees
Stall Torque (4.8V): 9kg.cm
Stall Torque (6.0V): 11kg.cm
Operating Angle: 45 Deg. one side pulse traveling 400usec
360 Modifiable: Yes
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 8.8mA/idle and 350mA no load operating
Current Drain (6.0V): 9.1mA/idle and 450mA no load operating
Dead Band Width: 4 usec
Motor Type: 3 Pole Ferrite
Potentiometer Drive: Indirect Drive
Bearing Type: Dual Ball Bearing
Gear Type: All Metal Gears
Connector Wire Length: 11.81" (300mm)
Dimensions: 1.59" x 0.77"x 1.48" (40.6 x 19.8 x 37.8mm)
Weight: 1.94oz. (55.2g)
Itt a link:
http://cgi.ebay.fr/TowerPro-MG995-Metal-Gear-Servo-Professional-Speed-R-C_W0QQitemZ180010649298QQihZ008QQcategoryZ774QQcmdZViewItem
Az lenne a kérdésem hogy akkor most melyik adat a helyes?
Roli